|
|
|
|
Step 1
|
Use regular glass cleaner or rubbing alcohol and clean
surface thoroughly. Surface must be
clean of dirt, dust, oil, and wax.
|
|
Step 2
|
Begin to peel the transfer tape (Sticker stays on the
transfer tape).
|
|
Step 3
|
Put the transfer tape (with
Sticker) on the surface.
|
|
Step 4
|
Starting from the top center,
slowly and firmly begin to apply the sticky side of the Sticker to the
application surface with a plastic squeegee (you can use your credit card
or ID).
|
|
Step 5
|
Let it sit for about 30
seconds. This will help release the adhesive from the transfer tape. Begin
removing the transfer tape peeling from one of tape top corner to the
bottom of the opposite corner. Any small bubbles can be removed by poking
a small hole and pushing the air out of the bubble with
finger.
|
| Installation instructions for tall Stickers |
|
Step 1
|
Clean the surface thoroughly using alcohol or Windex. Surface must be clean of dirt, dust,
oil, and wax.
|
|
Step 2
|
Without removing the paper in
the back place the Sticker on the surface. Use the top portion of the tape
to fix the Sticker on the place.
|
|
Step 3
|
Leave the top portion of the
tape on. Start applying the Sticker from top to bottom by removing the paper
from back of the Sticker with one hand and applying the Sticker with the other
hand. (use squeegee or a credit card)
|
|
Step 4
|
Let the Sticker sit for about 30 seconds and then remove the transfer
tape slowly.
(Any small bubbles can be removed by poking a small hole and pushing
the air out of the bubble with finger.)
|
| Installation instructions widened Stickers |
|
Step 1
|
Clean the surface thoroughly using alcohol or Windex. Surface must be clean of
dirt, dust, oil, and wax.
|
|
Step 2
|
Without removing the paper in
the back place the Sticker on the surface. Use the side portions of the tape
to fix the Sticker on the place.
|
|
Step 3
|
Leave the right portion of the
tape on. Start applying the Sticker from right to left by removing the paper
from back of the Sticker with one hand and applying the Sticker with the other
hand. (use squeegee or a credit card)
|
|
Step 4
|
Let the Sticker sit for about 30 seconds and then remove the transfer
tape slowly.
(Any small bubbles can be removed by poking a small hole and pushing
the air out of the bubble with finger.)
|
| How to Remove the Sticker |
|
|
Heat the area where the Sticker is with a blow dryer and just peel the sticker back off.
If their is any sticker adhesive still left on the window just clean it off with window cleaner.
If the adhesive still left on the paint use “Bumper Sticker Remover” then just polish the area with car wax.
Stickers are not reusable. Once you've applied the Sticker you can not use it again.
|
Check My order status |
Photo Gallery |
Customer Testimonials
Contact Us |
Feedback |
Privacy |
Return Policy |
© 2002 CrownStickers.com
|
